Our Services
Engineering Partner, Not Just Assembly
We offer a structured path from your first RFQ to sustained mass production — with engineering support at every stage.
Service 01
NPI (New Product Introduction) Process
Our five-phase NPI lifecycle is designed to take your optical module design from feasibility to high-yield mass production with full engineering traceability.
| Phase | Activity | Deliverable |
|---|---|---|
1 Phase 1 RFQ | BOM Review & DFM Analysis | Feasibility Report |
2 Phase 2 NPI | Engineering Pilot Run (Low Volume) | Prototype Samples |
3 Phase 3 DVT | BERT / TDECQ & Stress Testing | Verification Report |
4 Phase 4 PVT | Process Optimization & Yield Setup | Golden Sample |
5 Phase 5 MP | Automated Mass Production | High-Yield 800G Modules |
BOM Review & DFM Analysis
→ Feasibility ReportWe review your bill of materials, identify component availability risks, and perform design-for-manufacturability analysis. You receive a detailed feasibility report with recommended design changes and cost estimates.
Engineering Pilot Run (Low Volume)
→ Prototype SamplesA small engineering pilot run (typically 10–50 units) to validate the assembly process, identify yield limiters, and produce initial prototype samples for your engineering team to evaluate.
BERT / TDECQ & Stress Testing
→ Verification ReportDesign Verification Testing using Keysight and Anritsu instruments. BERT, TDECQ, eye diagram, and thermal stress testing. All results are documented in a formal verification report.
Process Optimization & Yield Setup
→ Golden SampleProcess parameters are locked and optimized for yield. Control charts are established, and a golden sample is produced and archived as the production reference standard.
Automated Mass Production
→ High-Yield 800G ModulesFull-scale automated mass production with 24/7 operation, real-time SPC monitoring, and automated test coverage. Yield reports and traceability data are provided with each shipment.
Service 02
Full Turnkey Production
We handle the entire supply chain — from component procurement and kitting to final test and packaging. You provide the design; we deliver finished, tested modules ready for your customers.
Service 03
Custom Firmware & Coding
Our firmware team programs and validates MSA-compliant EEPROM data, DDM/DOM parameters, and custom vendor-specific fields. We support all standard form factors and management interfaces.